CRUSH GEAR CHASSIS

CRUSH GEAR CHASSIS

There are 6 types of chassis in the Crush Gear series

 

V1: The chassis of the original Crush Gear was produced with 1 bolt hole in the batterybox so there is no need to worry "thinking about setting a spin or dash. The rear chassis is not universal so not all rear bumpers / rear weapons can be mounted on the chassis can be installed.

 

VT: a.k.a Variable Transmuting is a development of chassis V1 where there are 4 holes in the batterybox so we can set our Crush Gear as we wish. first hole from front for spin, second for normal, third for semi-dash, and fourth for full-dash. Unlike V1, VT Chassis has universal rear so that any rear bumpers and rear weapons (except rear bumper V1) can be attached to this chassis, including IOD.

 

MVT / N: more sophisticated than VT where the battery box can be set / shifted without having to remove the bolt. consists of 4 parts, the main part of the chassis, battery box, dynamo cover, and gearset cover. so with this chassis if you want to remove the dynamo, just open the cover dynamo. or want to check the gearset just by removing the wheel and gearset cover. can be obtained from CG: Wild Haken, Gallop Horn, Breakdeath Schyte, and Geo Scorpio. This chassis has also been produced in aftermarket part in white form.

 

MVT / D: special chassis with a height from the bottom of the chassis to the top of the chassis is lower "5mm” from the other chassis type. We can call it" flatter "only, the batterybox part cannot be varied like the MVT / N or VT chassis. from 4 chassis parts such as MVT / N, suitable for dash settings, can be obtained from CG: Mega Dash Striker, Hidlander, Ark Cavalier, and Rushing Edge.

MVT / S: Special chassis with rear wheel hole higher than front wheel hole allowing the chassis to remain parallel to the ground when using large diameter wheel spin behind. because of this, the use of a normal diameter wheel is not recommended to be put behind because the wheel will not touch the ground. MVT / S also consists of 4 chassis parts. suitable for spin settings. This chassis can be obtained from CG: Mega Spin Lefter, Vort Granade, Beat Impulse, and Senki Gai-Oh.

 

ZVT / N / S: The chassis is up to date with the combined spec of MVT / N and MVT / S where we can set this chassis into normal mode by using a normal cover and pin to Normal (N) or spin mode by using spin cover and switchpin to spin (S). can be obtained from all CG series Nitro.

(source: https://www.facebook.com/notes/gear-fight-indonesia/chassis-type/226192087530535)